Slitting Machine Daily Maintenance And Preventive Measures.

Before using the slitting machine, check that the working position is correctly adjusted. If lubrication is required, grease should be added beforehand. At the same time, the tool of the tape scutter should be sharp.
The scutcher should also check the machine for abnormalities before work and enter the order to be processed into the computer. Before opening the slitter, the operator should first ensure that no one else is around to avoid accidental injury to others
Ensure that the voltage, current and hydraulic pressure are normal before starting the scutter to ensure the safe and effective operation of the equipment. During the operation of the scuttling machine, in order to avoid personal injury due to the involvement of the hand, it should be noted that the film roll or roll core in the operation cannot be touched by hand.
When operating the scuttling machine, be careful not to scrape or cut each roll core with a knife or hard object. After the slitter is put into operation, the working state of the equipment should be adjusted in time according to the production situation, to ensure that the slitter has moderate indentation, cutting without burrs, and the trimming position on both sides is appropriate.
The slitting machine should be cleaned and maintained regularly when not in use, so that it can be used directly next time. Pay attention to grease, reduce the lubrication of the reducer, lubricate the sleeve and shaft of the bushing, lubricate the air source processor, or check the various parts regularly
Check whether the screw is loose.
It should be noted that the slitter should not be maintained during maintenance. Wipe embossing wheels, rubber wheels and tightening shafts with corrosive chemicals.